DRAMeXchange - Price, Transactions, and research inside DRAM/Flash industry

It is currently Sun Mar 29, 2020 8:04 am

All times are UTC + 8 hours





Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Nema 17 stepper motor review
PostPosted: Tue Jan 14, 2020 4:08 pm 

Joined: Mon Nov 18, 2019 3:11 pm
Posts: 14
I have a Lulzbot Taz 4 3D printer with dual extruders. If you knows what a lulzbot Taz 4, 5, or 6 is, then you will also know that the dual extruder is relatively very heavy. I bought 17HS08-1004S to lighten the load. it has improved the print quality a bit especially with the models that have sharp corners and where the X gantry is required to make sudden reverse moves. Other than using shorter screws to mount the motor, it's a direct fit. I did not have to adjust any voltage or calibrate the filament feed rate. The connector for the wire is not included. I've printed two big prints and a couple of medium sized prints with the new setup with no issues. I have not experience any skips or binding with the motors. It was worth the upgrade.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 8 hours



Who is online

Users browsing this forum: No registered users and 15 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
© 2011 DRAMeXchange, a Business Division of TrendForce Corp. All rights reserved.